- Home
- Networking
- CCENT/CCNA ICND1 100-105
101.
Which of the following installation steps are more likely required on a Cisco router, but not typically required on a Cisco switch? (Choose two answers.)
- A.Connect Ethernet cables
- B.Connect serial cables
- C.Connect to the console port
- D.Connect the power cable
- E.Turn the on/off switch to “on”
- Answer & Explanation
- Report
Answer : [B, E]
Explanation :
Explanation :
102.
Which of the following commands might you see associated with the router CLI, but not with the switch CLI?
- A.The clock rate command
- B.The ip address address mask command
- C.The ip address dhcp command
- D.The interface vlan 1 command
- Answer & Explanation
- Report
Answer : [A]
Explanation :
Explanation :
103.
You just bought two Cisco routers for use in a lab, connecting each router to a different LAN switch with their Fa0/0 interfaces. You also connected the two routers’ serial interfaces using a back-to-back cable. Which of the following steps are not required to be able to forward IPv4 packets on both routers’ interfaces? (Choose two answers.)
- A.Configuring an IP address on each router’s Fast Ethernet and serial interfaces
- B.Configuring the bandwidth command on one router’s serial interface
- C.Configuring the clock rate command on one router’s serial interface
- D.Setting the interface description on both the Fast Ethernet and serial interface of each router
- Answer & Explanation
- Report
Answer : [B, D]
Explanation :
Explanation :
104.
The output of the show ip interface brief command on R1 lists interface status codes of “down” and “down” for interface Serial 0/0. Which of the following could be true?
- A.The shutdown command is currently configured for that interface.
- B.R1’s serial interface has been configured to use Frame Relay, but the router on the other end of the serial link has been configured to use PPP.
- C.R1’s serial interface does not have a serial cable installed.
- D.Both routers have been cabled to a working serial link (CSU/DSUs included), but only one router has been configured with an IP address.
- Answer & Explanation
- Report
Answer : [C]
Explanation :
Explanation :
105.
Which of the following commands do not list the IP address and mask of at least one interface? (Choose two answers.)
- A.show running-config
- B.show protocols type number
- C.show ip interface brief
- D.show interfaces
- E.show version
- Answer & Explanation
- Report
Answer : [C, E]
Explanation :
Explanation :
|
|
||||||||||||||||||||||||||||
